Question 13
A 20 Mbps link has a propagation delay of 100 μs. The transmitter employs the Stop-and-Wait protocol. Assuming each frame is 150 bytes long, what is the maximum data rate possible (in Mbps)? Note: In two point precision
Question 13: A 20 Mbps link has a propagation delay of 100 μs. The tr…
Show answer
Correct answer: 4.65 (accepted within ±0.05)
Question 13 of 42 in the IIT Madras BS Computer Networks (Computer Networks) End Term paper sat on 21 Dec 2025, in the September 2025 term (Computer Networks 18 Dec 25). It carries 3 marks.
More questions from this paper
- Assume a host in Mumbai wants to send a packet to a server in Delhi, approximately 1300 km away. If the signal travels …
- Assume a host in Mumbai wants to send a packet to a server in Delhi, approximately 1510 km away. If the signal travels …
- If the one-way latency between two cities is measured to be 35 ms, the RTT (Round Trip Time) assuming symmetric paths a…
- If the one-way latency between two cities is measured to be 15 ms, the RTT (Round Trip Time) assuming symmetric paths a…
- A transmitter sends packets of size 2100 bits at a rate of 4 Mbps from node X to node Y. The one-way delay is observed …
- A transmitter sends packets of size 2000 bits at a rate of 3 Mbps from node X to node Y. The one-way delay is observed …
- In a circuit-switched network, a source communicates with a destination through 10 intermediate switches. Each switch t…
- In a circuit-switched network, a source communicates with a destination through 5 intermediate switches. Each switch ta…
- Answers Case Sensitive : No
- Answers Case Sensitive : No
- A TCP connection uses the following identifiers:\ Source IP = 192.168.1.10 • Destination IP = 10.0.0.5 • Source Port = …
- A TCP connection uses the following identifiers:\ Source IP = 192.168.1.10 • Destination IP = 10.0.0.5 • Source Port = …
- A 20 Mbps link has a propagation delay of 400 μs. The transmitter employs the Stop-and-Wait protocol. Assuming each fra…
- If you are designing sliding window protocol (assume selective repeat) of 5 Mbps which has one way delay of 1.27 second…
- If you are designing sliding window protocol (assume selective repeat) of 7 Mbps which has one way delay of 1.55 second…
- In a network with a bottleneck bandwidth of 30 Mbps and a round-trip time of 50 ms,what should be the minimum congestio…
- In a network with a bottleneck bandwidth of 25 Mbps and a round-trip time of 400 ms,what should be the minimum congesti…
- A TCP flow has a congestion window of 86 KB and an RTT of 450 ms. Calculate the average throughput in Mbps. Note: In tw…
- A TCP flow has a congestion window of 54 KB and an RTT of 510 ms. Calculate the average throughput in Mbps. Note: In tw…
- In TCP BBR’s bottleneck bandwidth estimation, the ACK arrival rate measured over an epoch gives a delivery rate of 84 M…
- In TCP BBR’s bottleneck bandwidth estimation, the ACK arrival rate measured over an epoch gives a delivery rate of 48 M…
- A TCP Reno connection detects congestion when CWND = 200 KB. After triple duplicate ACK, CWND is reduced to 1/4, and ad…
- A TCP Reno connection detects congestion when CWND = 100 KB. After triple duplicate ACK, CWND is reduced to 3/4, and ad…
- An ISP manages a network block of 200.8.0.0/12. it partitions and assigns a customer a smaller block 200.8.4.128/18. Ca…
- An ISP manages a network block of 200.8.0.0/10. it partitions and assigns a customer a smaller block 200.8.4.128/22. Ca…
- How many distinct prefixes can a /12 block be divided into when it is subnetted up to /16 networks?
- How many distinct prefixes can a /10 block be divided into when it is subnetted up to /18 networks?
- An organization has 1900 devices connected in a private network. Each NAT router can handle up to 90,000 simultaneous c…
- An organization has 2,200 devices connected in a private network. Each NAT router can handle up to 80,000 simultaneous …
- When using Dijkstra’s algorithm to find shortest path in a graph, which of the following statement is not true?
- When using Dijkstra’s algorithm to find shortest path in a graph, which of the following statement is not true?
- The browser connects (TCP handshake visible) but the webpage never loads. What is the MOST likely issue?
- The browser connects (TCP handshake visible) but the webpage never loads. What is the MOST likely issue?
- The server prints the GET request in console but the browser keeps “Waiting for localhost...”.Why?
- The server prints the GET request in console but the browser keeps “Waiting for localhost...”. Why?
- Figure question
- Figure question
- Figure question
- Figure question
- Figure question
- Figure question